Hi i used to have an assembly of my machine bed where I used to just insert components, mate the bottom face to the top plane and drag it or mate it to where i need it onto the table. After downloading 2018 i didn't save this assembly and need to know how i can remake it.

 

I'm not sure now how i can get my component onto my machine without this set up and can't believe how difficult and complicated it seems to be to remake it as all it was was a 1500x1500 rectangle on the top plane with X0Y0 being the bottom left corner and the top plane my Z0

 

Thanks


Categories: Modeling and Assemblies, Assemblies

Comments
Last comment By: Glenn Schroeder   Wed, 14 Feb 2018 20:42:31 GMT
Re: Custom assembly? Machine bed as assembly

How did you lose it?  I guess it doesn't matter, but don't you have any existing files you can use as a starting point to recreate the basic Assembly?

By: Glenn Schroeder  Wed, 14 Feb 2018 20:42:31 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.