no highlight.JPGhighlight.JPG


Categories: Modeling and Assemblies, Parts and Features

Comments
Last comment By: Christian Chu   Thu, 12 Oct 2017 20:13:23 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

Upload you file and you will have a better chance to get help

By: Vladimir Urazhdin  Wed, 11 Oct 2017 23:50:27 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

Have you thought about sheetmetal tools.

ScreenShot_20171012164250.png

ScreenShot_20171012164224.png

By: Ned Hutchinson  Thu, 12 Oct 2017 06:14:14 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

I am aware of sheetmetal tools, but I have never used it. I was trying to stick with what I was a bit more familiar with, but if needed I will go that route.

By: Josh Chandler  Thu, 12 Oct 2017 13:57:28 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

Part File

By: Josh Chandler  Thu, 12 Oct 2017 12:41:54 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

This is the way to go: Ned Hutchinson post.

One of the huge advantages of Sheet Metal tools is the automatically generated flat pattern - it saves a lot of time for tool makers.

By: Vladimir Urazhdin  Thu, 12 Oct 2017 17:38:02 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

Now's the time to start learning

By: John Stoltzfus  Thu, 12 Oct 2017 17:47:26 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

nice job, Ned

By: Christian Chu  Thu, 12 Oct 2017 19:56:04 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

Yeah, that was way easier that what I was trying to do.  Thanks

By: Josh Chandler  Thu, 12 Oct 2017 19:46:16 GMT
Re: I have a duct transition from rectangular to round, I cannot make the fillet work to match the round end of the duct. Any ideas?

You can model this part with diff. approach, but Ned's model is a nice way for sheet metal flat-pattern

Here is another way - see att. model - just overlay your model

 

By: Christian Chu  Thu, 12 Oct 2017 20:13:23 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.