We use cookies to operate this website, improve its usability and track visits. Please note that by using this site you are consenting to the use of cookies.
Learn More |

Hello guys, hope some of you can answer this, cause i am quite stuck in there...

I want the little piece of metal from the black plastic bracket to bend whenever i screw in or out from the slot. I respectively named the 3 files to open : Open_this_one1  Open_this_One2, Open_this_One3

 

My problem is the follwing : I created a configuration which allows the little metal bracket to flex just about 45 degrees, but when i assembly that to the support, it just pop up a error message. What did i do wrong?

 

Thank you!!


Categories: Simulation, Motion Studies

Comments
Last comment By: Deepak Gupta   Thu, 14 Sep 2017 05:57:38 GMT
Re: Motion study of adjustable knife.

Hi Pascal,

We can not simulate flexible bodies using Motion Analysis.

We can only do rigid body analysis. So bending metal piece is not possible.

For configurations error please share files

By: Amit Nara  Thu, 14 Sep 2017 05:23:30 GMT
Re: Motion study of adjustable knife.

If you're looking for animation only then it might be doable. Share files to see what you're trying to do.

By: Deepak Gupta  Thu, 14 Sep 2017 05:57:38 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.