Hello, I am working in weldments, after I have created a 3D sketch and run a couple of structural members if I change a dimension in the sketch the front place rotates to be parallel to the right plane. Do you know why this is happening and how I can fix it? Below is a snapshot of all three planes on in my part. I have restarted both Solidworks and my computer.

 


Categories: Modeling and Assemblies, Weldments

Comments
Last comment By: Hannah Davis   Mon, 26 Mar 2018 17:36:43 GMT
Re: Hello, I am working in weldments and after I have created a 3D sketch and run a couple of structural members if I change a dimension in the sketch the front place rotates to be parallel to the right plane. Do you know why this is happening and how I c

Hello,

 

Why is the 3DSketch in error? What does SW say what's wrong with it?

Fix that and perhaps your OP will be okay.

 

Also, can you upload the part? (Replies generally improve since less guessing is required)

 

Cheers,

 

Kevin

By: Kevin Chandler  Sat, 24 Mar 2018 20:49:14 GMT
Re: Hello, I am working in weldments and after I have created a 3D sketch and run a couple of structural members if I change a dimension in the sketch the front place rotates to be parallel to the right plane. Do you know why this is happening and how I c

I do not see the front plane in your screen shot.  Are you sure the sketch has not rotated?

 

However, I agree with Kevin Chandler, please upload your model and as JD Mather often states and "end all doubt" (or something like that).

By: Solid Air  Sat, 24 Mar 2018 21:26:51 GMT
Re: Hello, I am working in weldments and after I have created a 3D sketch and run a couple of structural members if I change a dimension in the sketch the front place rotates to be parallel to the right plane. Do you know why this is happening and how I c

Problem resolved. Weldment profile was bad, which caused the front plane to rotate.

By: Hannah Davis  Mon, 26 Mar 2018 17:36:43 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.