Preview   |   SOLIDWORKS User Forum

 Add offset on smart fastener
Gustav Rydn   |  1 year ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

Is it possible to make the bolt offset from the surface that you select for inserting the fastener?

I cannot select the plate, only the beam in the "Selection"-box. Therefore the nut lays flat against the beam. But I want it to lay flat against the plate (which is 15 mm or 0.6 inch thick).

SolidworksToolbox



You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.