Preview   |   SOLIDWORKS User Forum

 Sheet metal lofted bend - radius too big
Thomas Bayley   |  8 months ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

Hi there,

I need to get a lofted sheet metal bend modelled up using the sketches 4 and 9 in the model attached. But I continued to get an error message telling me the radius is too big. It aims to get a small piece sheet metal attached on top of the outside surface. The purpose is to get a flat pattern out of this lofted bend. 

Can anyone please help?

Thanks in advance.  

SolidworksModeling And Assemblie



You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.