Preview   |   SOLIDWORKS User Forum

 automatic creation of flat pattern
Lauritz Berg   |  8 months ago
Open in Forum   

All you need is a 3DEXPERIENCE ID.

When we start a solidworks drawing with a template with pre-defined views in it & the part is a sheet metal part it automatically creates a flat pattern for the configuration you start it from.
This flat pattern is NOT used in those views. It just exists.
When I try to delete it from the part with the drawing open - I cannot.
I close the drawing, delete the flat pattern, open the drawing again, get the








You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.