Preview   |   SOLIDWORKS User Forum

 SW electrical tiered terminal diagrams
Wayne McAneaney   |  14 days ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

Is it possible to depict 2-tier terminals [source and destination] so they look the same in the terminal diagram drawings?

At the moment my SW configuration shows the source terminal strip graphically as 2-tier [1.1 = term 1 lower / 1.2 = term 1 upper] which is fine, but confusingly depicts the destination terminal as only a rectangular symbol which omits the level number and instead places the terminal




You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.