Preview   |   SOLIDWORKS User Forum

 No error message when thicken or offset fail SW09 sp3
Matt Lombard   |  13 年 前
Open in Forum   

您只需要 SOLIDWORKS ID 或新的或現有的 3DEXPERIENCE ID。

I'm working in sw09 sp3, vista 64, and when I try to make aThicken or Offset surface feature and the feature fails, SW doesn'tgive an error message.

Any one else seeing this?

Also, when doing a Tools, Check and looking for minimum radius, thearrow often points to an area off the part that was trimmed off inan earlier operation. Not sure if any of this is new with sp3 ornot.

SolidworksParts And Features



您未獲授權,無法檢視此頁面 找不到結果!建議:檢查拼字,嘗試不同的搜尋,或瀏覽下方的主題。