Preview   |   SOLIDWORKS User Forum

 No error message when thicken or offset fail SW09 sp3
Matt Lombard   |  13 년 전
Open in Forum   

필요한 것은 SOLIDWORKS ID 또는 신규 또는 기존 3DEXPERIENCE ID입니다.

I'm working in sw09 sp3, vista 64, and when I try to make aThicken or Offset surface feature and the feature fails, SW doesn'tgive an error message.

Any one else seeing this?

Also, when doing a Tools, Check and looking for minimum radius, thearrow often points to an area off the part that was trimmed off inan earlier operation. Not sure if any of this is new with sp3 ornot.

SolidworksParts And Features



이 페이지를 볼 권한이 없음 찾은 결과가 없습니다! 제안: 맞춤법을 확인하고 다른 검색을 시도하거나 아래 주제를 찾아보십시오.