Preview | SOLIDWORKS User Forum
No error message when thicken or offset fail SW09 sp3
Matt Lombard | 13 Jahre Vor
Open in Forum
Alles, was Sie dafür benötigen ist eine SOLIDWORKS ID bzw. eine neue oder bereits vorhandene 3DEXPERIENCE ID.
I'm working in sw09 sp3, vista 64, and when I try to make aThicken or Offset surface feature and the feature fails, SW doesn'tgive an error message.
Any one else seeing this?
Also, when doing a Tools, Check and looking for minimum radius, thearrow often points to an area off the part that was trimmed off inan earlier operation. Not sure if any of this is new with sp3 ornot.
SolidworksParts And Features
Any one else seeing this?
Also, when doing a Tools, Check and looking for minimum radius, thearrow often points to an area off the part that was trimmed off inan earlier operation. Not sure if any of this is new with sp3 ornot.
SolidworksParts And Features