Preview   |   SOLIDWORKS User Forum

 No error message when thicken or offset fail SW09 sp3
Matt Lombard   |  13 years ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

I'm working in sw09 sp3, vista 64, and when I try to make aThicken or Offset surface feature and the feature fails, SW doesn'tgive an error message.

Any one else seeing this?

Also, when doing a Tools, Check and looking for minimum radius, thearrow often points to an area off the part that was trimmed off inan earlier operation. Not sure if any of this is new with sp3 ornot.

SolidworksParts And Features



You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.