Preview   |   SOLIDWORKS User Forum

 Can't Trim/Extend Weldment at an angle
Powell Barber   |  11 months ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

I'm unable to trim the angled pieces in this weldment model.  All of the perpendicular pieces worked fine, and I've done this very thing in other weldments. 

The Trim/Extend operation shows the correct preview, but once the green check is selected, there is no change in the model!

I'm simply trying to trim the 2" x 3" gussets up to the face of the 3" x 3" square tube.

SolidworksModeling And Assemblie



You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.