Preview   |   SOLIDWORKS User Forum

 Section view dimensions
Dev Dahifale   |  4 months ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

Hii everyone,

I want to add dimensions to only hole edges in section view. Is it posible to recognise hole edges in  section view?

I tried it using edge feature type but in section view i am not getting perfect type. Is there any right direction to find it?  Thanks in advance..

SolidworksApi/macros



You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.