Preview   |   SOLIDWORKS User Forum

 Trim/extend: allow extension goes through other side of tube
Kobe Van de Vyver   |  1 month ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

Hi! 

I am building a chassis and encountered a problem when trimming my tubes. Whenever I use the trim/extend feature and select the allow extension feature, my tube gets trimmed on both side, instead of only the side where the other tube connects (see first picture). 

When I don't use the allow extension feature, my tube doesn't seem to be cut and this also gives a rebuild error (see second picture)




You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.