Preview   |   SOLIDWORKS User Forum

 Shaft simulation
the chalota   |  1 month ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

Hello, i am simulating a shaft in torsion and bending. The fixtures are two bearings, one of them with the "stabilize shaft rotation" box checked, and the other without that, both with "allow self alignmente" activated. The Force load is applied in the middle betwen two bearings fixtures and the torsion load at the end f the shaft, like is showed in the image below:

The simulation general response it

You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.