Preview   |   SOLIDWORKS User Forum

 SET GENERAL TABLE ANCHOR ON SHEET 1
Solidworks Forum   |  13 years ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

I FOUND OUT THAT WHENEVER I CREATE A NEW DRAWING, THERE IS NOOPTION FOR SETTING UP AN ANCHOR POINT FOR 'GENERAL TABLE' ON 'SHEETFORMAT1' IN FEATURE TREE. I FOUND THAT I HAVE TO ADD A NEW SHEET INORDER TO CHANGE A GENERAL TABLE ACHOR. ANY SUGGESTIONS ON SETTINGTHIS OPTION FOR SHEET FORMAT 1??

THANKS.SolidworksBill Of Materials



You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.