Preview   |   SOLIDWORKS User Forum

 Spiral Sketch/Etch Lines for CNC Laser
Daniel McCarron   |  3 hours ago
Open in Forum   

All you need is a SOLIDWORKS ID, or a new or existing 3DEXPERIENCE ID.

Hi everyone,

I'm looking to add sketch lines to the outer diameter of Steel Tube so a CNC Tube Laser can pick these up and etch the lines to make it easier to center tabs for welding. 

As it's a spiral design I'm currently copying and pasting a sketch (that you will see on the middle 'right' plane) on each plane and trimming away until I'm left with what I want to be etched (on that particular plane).




You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.