You are using a web browser or a browser version not supported by this website! This means that some functions may not work as expected.
Use or upgrade/install one of the following browser to take full advantage of this site
Internet Explorer 9 and above
Can anyone help me to flatten the attached part or convert to sheet metal please.
Categories: Modeling and Assemblies, Sheet Metal
Joji,,, The best I could come up (it gave me fits) with is to do this as a lofted bend with a tiny flat (note my Cut-Extrude8) at the coped (open) end of the cone. Normally you can easily do an insert bends on a revolved cone but since this was made from a thickened Surface-Loft that won't work. Your original body is still in the file just hidden. You can unhide it to compare the two and see that they match up.
It seems new concept for me thanks for introducing it.
Thanks for your efforts, but its is really confusing me.
Is there any standard method to successfully do this from the beginning?
Previous one edited.
thanks a lot for all the efforts, I was able to remodel my part with the ideas given by everyone.
thanks once again