hello, I am not sure if anyone else out there is having this problem i am using XP sp2 every time i open edrawing and try to open a drawing it immediately crashes any idea's? thank you DawnSolidworksWeldments
15 yıl önce
How can I get my weldment parts to explode like in an assembly?SolidworksWeldments
15 yıl önce
Has anyone (other than me) had a problem inserting parts within weldments (it worked fine in 2008 but in 2009 The program is crashing every time I try to do it does anyone have any ideas? Thanks AlexSolidworksWeldments
15 yıl önce
Example: If I have a piece of tubing with angled cuts on each end - the cutlist gives me those angles. But, are they parallel or mirrored? Is there any way to specify what direction the angled cuts are in the cutlist without having to detail the part? thank you, SolidworksWeldments
15 yıl önce
hi all, I have created a weldment assembly. I have created its drawing and insert a relative view in which i have selected a parts which i need to show in drawing view. My question is what if i want to add a part in that view ? How can i add a part in to that relative view later on ?
15 yıl önce
Hi, Elemento strutturale2 don't trim automatically and even with trim/extend command. I am wrong something or the only solution is using 2 cuts extrusion ? Regards, AlessandroSolidworksWeldments
15 yıl önce
Hi, there is an option to avoid the extension figured in the attached image and without to use the trim/extend command ? We use lot of Rexroth profile and the trim/extend command weigh down to much the file. Thank you, AlessandroSolidworksWeldments
15 yıl önce
Is it possible to put in a mitred cut angle column on a weldment cut list, i.e. structural members that are mitred would have a column that specifies what angle they are mitred at.SolidworksWeldments
15 yıl önce
Any idea how to use Toolbox structural members (for example DIN IPE-bars) as structural members in weldment parts ? .. Hope You all understand, what I'm trying to say ??
15 yıl önce
