Catégories:
Trier:
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
I am currently practicing the CSWP practice exam provided by SolidWorks however I am stuck on problem 4. I know there is some problem as shown in the picture but when I measure it, I just get the correct dimension. I would really appreciate it if someone can take a look at my attached part and see what places I got wrong. Thank you!
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
Hi, is it possible to make a sketch 1 XY witch lines/arks, and sketch 2 XZ withch a lines/arks and then use a "magic wand" to get 3D sketch of intersection of these two? I know i can extrude surfaces out of these two sketches and then use intersection which gives me what i want, however I'm looking for the same outcome without having the surfaces Here is example of 2 surfaces and intersection: SolidworksParts And Features
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a
SOLIDWORKS User Forum
1 année il y a