Categories:
Sort:
The following two images are part of an assembly modeling practice question. I attempted the question and a link to the assembly I made is Assembly question solidworks.SLDASM - Google Drive. I think I have assigned all mates except the angle mates correctly, which causes my model to look completely different from that shown in the images below. I added the angle mates as shown in the images based on the coordinate system 1 that I added to match the coordinate system shown in the drawing views.
SOLIDWORKS User Forum
5 days ago
Occasionally I get jobs where I have to deal with sketches extracted from DWG files, that consist of many lines including splines. In general I find Solidworks performance to be utterly dismal. Especially with splines, my workflow grinds to a halt, and sometimes I cant even complete jobs or need to break them down into very small steps just to get it finished, which is more work than it should be. When checking my system performance, my CPU and RAM have plenty of headroom to play with yet
SOLIDWORKS User Forum
5 days ago
no listings for subjects of posts. very unfriendly interface. Worthless forum that I can not use effectively. Solidworks has gone the wrong direction this is a redit type setup. Not a professional forum.
SOLIDWORKS User Forum
5 days ago
I made an assembly with several subassemblies that have configurations. After deleting some of the configurations, I can no longer save any part, subassembly or assembly that ever included it, so I am completely stuck. If I didn't have the 3DExperience Connector installed, normally I wouldn't have any problem after this, but now the Collaborative Space has all of the configurations saved as "Physical Product" files and I can't even delete these obsolete configurations. Basically, I just want to
SOLIDWORKS User Forum
5 days ago
I gave someone a link to a thread (opened it in a new tab and tried just from opening the thread) Are you serious?
SOLIDWORKS User Forum
6 days ago
SOLIDWORKS User Forum
6 days ago
SOLIDWORKS User Forum
6 days ago
SOLIDWORKS User Forum
6 days ago
SOLIDWORKS User Forum
6 days ago
SOLIDWORKS User Forum
6 days ago
SOLIDWORKS User Forum
6 days ago
If you do, will you share it? Thank you
SOLIDWORKS User Forum
6 days ago
....is what using 3DSwym is like. Is there a tutorial thread on how to use this? I need one, just to find one.....
SOLIDWORKS User Forum
7 days ago
SOLIDWORKS User Forum
7 days ago
SOLIDWORKS User Forum
7 days ago
When doing a section of a model (in 3D, not for a drawing) is there a way to snap the section plane to the centre of a hole/cylinder if that holes doesn't lie on the standard planes? In CATIA you can simply click the hole and the section plane will snap to this. Even more useful, if you had a plate with a hole through the centre and then a hole pattern on a PCD around it you can pick the centre hole and one of the outer holes and it will section using a plane through these 2 holes which is great
SOLIDWORKS User Forum
7 days ago
SOLIDWORKS User Forum
7 days ago
I'm very probably posting this in the wrong place... If so, please redirect me. A lot has changed since I was here last! I have a drawing of a simple assembly.
SOLIDWORKS User Forum
7 days ago
SOLIDWORKS User Forum
7 days ago