Korzystasz z przeglądarki sieci Web lub przeglądarki w wersji nieobsługiwanej przez tę stronę internetową! Oznacza to, że niektóre funkcje mogą nie działać zgodnie z oczekiwaniami.
Aby w pełni skorzystać z tej witryny, zastosuj lub uaktualnij/zainstaluj jedną z następujących przeglądarek
Miejsce, w którym użytkownicy SOLIDWORKS zdobywają informacje, dyskutują i dzielą się wiedzą na temat 3DEXPERIENCE Works — od oprogramowania SOLIDWORKS na komputery stacjonarne poprzez rozwiązania częściowo korzystające z chmury aż po rozwiązania całkowicie oparte na chmurze.
Wystarczy zalogować się za pomocą SOLIDWORKS ID lub nowego/istniejącego 3DEXPERIENCE ID.
Every dimension you see in the image above is assigned to the Front Annotation View. Additionally, they're all on the same plane. So, my question is this: WHY, when I activate and orient to the Front view, is the leader for the 32mm diameter hole hidden where it touches the model? SolidworksMbd
When using MBD, I am unable to actually publish to a 3D pdf on some parts. For other parts, it works fine. Is there any reason why this might be? SolidworksMbd
Hello, When trying to publish to a 3D PDF from Solidworks MBD I get a "Permission denied on themes folder" error. See attached for popup. I do not know where the 'themes' folder is. I do not know where to grant permissions I will try re-installing SW to see if it fixes it but I like to put records down when I can, and couldn't find one on this particular issue. SolidworksMbd