Şuradaki yenilikler:

SOLIDWORKS Kullanıcı Forumu

SOLIDWORKS kullanıcılarının 3DEXPERIENCE Works: SOLIDWORKS masaüstü, bulut bağlantısı ve saf bulut hakkında keşif, etkileşim ve paylaşım yaptığı yer.

SOLIDWORKS ID'nizle veya yeni ya da mevcut bir 3DEXPERIENCE ID'siyle oturum açmanız yeterli.

Sıralama ölçütü::
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
Is there a way I can get this sort of view in Solidworks 2019? It's a flow simulation cut plot I believe from a previous version of solidworks. I can't seem to get a clear enough fluid trajectory view in 2019 SolidworksFlow Simulation
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
I'm having issues with Flow Simulation. The Flow Simulation tab is missing and I can't get it to show up. I'm new to flow simulations but it appears I can run the simulation, but I can't create lids without the lid creator which is under the missing tab. How do I get that tab to appear?
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
I figured out that my porous media was working correctly, but it was a plotting problem where the upper limit was automatically set too low.. SolidworksFlow Simulation
SOLIDWORKS User Forum
1 yıl önce
SOLIDWORKS User Forum
1 yıl önce
I was trying to use flow simulation and as I press run, it starts to generate mesh but suddenly "Solver abnormally terminated" appears and it happens only for this model because I've tried flow sim for other models but it worked there. I have no idea how to fix this, please help me. SolidworksFlow Simulation
SOLIDWORKS User Forum
2 yıl önce
I am trying to simulate a bi-plane wing. I did a mesh convergence study with the initial mesh and the force in the X and y-direction for "initial meshes from 1-5" are not converging. Mesh level 6 is taking over 2 days to run. Tips?
SOLIDWORKS User Forum
2 yıl önce
Best regards Someone will have some table of manning roughness expressed in micrometers to introduce to the solidworks flow simulation. Thank you SolidworksFlow Simulation
SOLIDWORKS User Forum
2 yıl önce
I am new to SolidWorks Flow Simulation. I have been trying to create a lift curve for a wing. I have not figured out how to do that. Any help is greatly appreciated!
SOLIDWORKS User Forum
2 yıl önce
Good evening, I am currently working on this project but I have wrong values when I start the calculation (on flowsimulation). Can someone here solve the problem? I do not understand why ... SolidworksFlow Simulation
SOLIDWORKS User Forum
3 yıl önce