I have been asked to create wire bonds in a PCB assembly. I have the xyz coordinates of the start and finish points along with the wire bond length. Does anyone know how i can go about to get this done?


Categories: SOLIDWORKS PCB

Comments
Last comment By: Injy Gadalla   Wed, 16 May 2018 22:44:45 GMT
Re: Ability to create wire bonds from an excel list of xyz coordinates and assign loop height in SolidWorks PCB assembly?

Hello Mark,

 

I have attached a comprehensive document on how to create a wire bond in SOLIDWORKS PCB.

I hope this will provide the information and details you are looking for.

 

Best Regards,

Injy Gadalla

Territory Technical Manager, SOLIDWORKS PCB

By: Injy Gadalla  Wed, 16 May 2018 22:44:45 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.