I've created a connection table for a connector that has pins scattered throughout the schematics.  The intent is to ease look up of destination for a particular pin.  However, when I place the connection table the ordering seems somewhat random.  I would like to order the table by the pin (origin) number. Does anyone know how to sort the table?

I'm currently using SWE 2017.

 


Categories: SOLIDWORKS Add-Ins, Electrical

Comments
Last comment By: Evan Stanek   Wed, 14 Feb 2018 21:34:47 GMT
Re: How can I sort a connection table?

Scott, GREAT question, there are TWO flavors of connection labels, RED (component order) or BLUE (part order).  By choosing the blue order you will get the pins circuits listed out according to the part circuitry, not however they were reordered at the component level.  So, here's how you get the BLUE connection label.

 

By: Evan Stanek  Wed, 14 Feb 2018 21:34:47 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.