2.25  diametral pitch can not be found in toolbox.


Categories: Modeling and Assemblies

Comments
Last comment By: Jack Qian   Wed, 22 Nov 2017 12:51:08 GMT
Re: How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch can not be found in toolbox. , How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch

2.25Diametral pitch can not be found in toolbox.pngDiametral pitch gear2.png

By: Jack Qian  Wed, 22 Nov 2017 03:49:19 GMT
Re: How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch can not be found in toolbox. , How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch

Mabye try download this free software make your own

Forest Moon Productions - GearDXF

ScreenShot_20171122143253.png

By: Ned Hutchinson  Wed, 22 Nov 2017 04:04:07 GMT
Re: How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch can not be found in toolbox. , How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch

Jack Qian,

A few things to help you out:

1. A single post will do.  Please delete these others:  The specified item was not found.  and The specified item was not found.

2. Toolbox does not make real involute gears in the first place so unless it is for a simple representation of a gear it is worthless.

3. You did not specify anything else about the gear such as pressure angle or number of teeth.

4. I have attached a parametric spur gear file I made in SWX2014 for inch sizes.  It uses a Design Table.  Simpy edit the DT to set the number of teeth, pressure angle and diametral pitch and it will generate an accurate gear for you to work with.

By: Dennis Dohogne  Wed, 22 Nov 2017 12:37:19 GMT
Re: How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch can not be found in toolbox. , How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch

Hello Ned,

 

Thank you very much.

 

Best regards,

 

Jack

By: Jack Qian  Wed, 22 Nov 2017 12:50:01 GMT
Re: How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch can not be found in toolbox. , How to produce a 3d model of gear with 2.25 diametral pitch by using solidworks toolbox?2.25 diametral pitch

Hello Dennis,

 

Thank you very much.

 

Best regards,

 

Jack

By: Jack Qian  Wed, 22 Nov 2017 12:51:08 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.