We use cookies to operate this website, improve its usability and track visits. Please note that by using this site you are consenting to the use of cookies.
Learn More |

Hello,

 

I am attempting to create a fillet on a 3D sketch. However, it tells me I can't use the fillet command because I "cannot fillet curves that are no co-planar". Does anyone have any techniques or workarounds you could share and demonstrate how to fillet this 3D sketch where the arrow is pointing?

 

3DFillet.png

 

Thanks in advance for your help.


Categories: Modeling and Assemblies, Sketching

Comments
Last comment By: Mark Dougall   Fri, 13 Oct 2017 09:29:41 GMT
Re: Help creating fillet in 3D sketch

I do not know whether this way is correct.

1.png

By: Maha Nadarasa  Fri, 13 Oct 2017 01:11:42 GMT
Re: Help creating fillet in 3D sketch

Mathematically there is no way to connect your two elements with an arc tangent to both. That is when the line (or extended line) is intersecting the large arc.

So you must make a compromise:

  • Move the line as Maha Nadarasa suggest.
  • Create a connecting spline.
  • Accept non tangency between the elements.
  • Probably som other options.
By: Thomas Voetmann  Fri, 13 Oct 2017 05:44:02 GMT
Re: Help creating fillet in 3D sketch

I am not a fan of 3D sketching. But I think you can achieve what you want using "project curve".

By: Bernard Pepito Malolos  Fri, 13 Oct 2017 07:15:36 GMT
Re: Help creating fillet in 3D sketch

Can you make the line between the two 10 degree construction lines at a 90 degree angle to the initial line and Tangent to the large circle? If so you could probably fillet it.

By: Mark Dougall  Fri, 13 Oct 2017 09:29:41 GMT
You are not authorized to view this page No results found! Suggestions: Check spelling, try a different search, or browse topics below.